Разборка ноутбука Acer Aspire E1-531 [ENG]
Today I will be taking apart an Acer Aspire E1-531-2438 laptop.
My goal is to access and replace the cooling fan which failed and started making noise. Cleaning the fan didn’t help.
Most likely this guide will fork for other Aspire E1 series models.
Make sure the laptop is turned off before you start taking it apart.
Unlock and remove the battery.
Using a small flathead screwdriver push on the latch securing the keyboard.
At the same time insert something under the keyboard and lift it up.
There are six latches securing the keyboard on the top.
After you release all of them, you should be able to lift up the keyboard as it shown on the following picture.
Now you can access and unlock the cable connector.
In order to unlock the connector you’ll have to slide the cable retainer about 2-3 millimeters to the shown direction.
Now, after the connector is unlocked, you can pull the cable.
Remove the keyboard.
Remove two screws securing the bottom cover.
Remove the cover.
Under the cover you’ll find the hard drive, both RAM modules and Wi-Fi card.
Pull the hard drive to the left to disconnect it from the motherboard.
Remove the hard drive.
Remove one screw securing the optical drive.
Pull the optical drive to the left and remove it.
Remove all screws from the bottom of the laptop.
Disconnect the power button cable and touchpad cable (same technique as shown in steps 6-7).
Lift up the top cover and start separating it from the bottom.
I’m using a guitar pick to split the case.
Remove the top cover (palm rest) assembly.
On the other side you can access the touchpad and power button board.
When the top cover removed you can access the CMOS battery.
As you see, the cooling fan mounted under the motherboard. Let’s remove it.
Disconnect both antenna cables from the wireless card.
Remove one screw securing the Wi-Fi card and pull it from the slot.
Un-route the white antenna cable.
You can leave the black cable in place.
Pull the white cable though the opening and un-glue it from the motherboard.
Remove two screws securing the motherboard.
Disconnect five cables.
Here’s how to disconnect small connectors.
Simply unplug the male part from the female part. Do not pull by the wires. Unplug by the connector edges.
Here’s how to disconnect the display cable.
Start removing the motherboard from the case as it shown on the following picture.
Be careful. The motherboard is connected to the DC jack cable.
Unplug the DC jack cable.
Finally, we can access the cooling fan.
Remove three screws securing the fan and disconnect the cable.
Remove the failed fan and replace it with a new one.
Всё! Ноутбук разобран. Сборка происходит в обратном порядке, если у вас возникнут сложности вы всегда можете обратиться к специалистам.